Device DefinitionA Device Definition is a template from which you create actual devices. In this view you have all the information available for the definition being presented.
The Dev Type value is a link you can use as a shortcut to get back to the Device Library. The Hash Number is a unique identifier you will use in certain operations, optionally some times. In the case of frames, there is also a Slots Count field. If you plan to change this info, press the [Edit] button located at the bottom of the page.
The [Existing Devices] button will take you to a list of all devices that have been created from this definition.
It follows the Inputs/Outputs table listing all of the ports showing: Label, Signal Type and Connector Type. Label refers to that bared in the physical equipment. You can change a port information by clicking in the Edit link located in the corresponding row.
In the case of type FRAME, there is usually no ports. Some frames, however, have ports such as Black Burst, Serial and Ethernet.
To add new ports (either input or output), click the [Add Ports] button.
Buttons [Remove Inputs] and [Remove Outputs] will remove all input or output ports respectively. You will be prompted for confirmation before proceeding.
Keep present that you won't be able to make any change if you are not logged in.
----
If you plan to create a device from this definition, you need to navigate to the location (Rack, Desk or Frame Slot) where the device will reside and press the [Add Device] button on that view.
----
It is recommended that you create device definitions as complete as possible. The recommended practice is to use the manufacturer's manual or datasheet as a direct reference. Nevertheless, if the definition is some how incomplete, you will be able to add/modify/delete ports in the actual device created from this definition later on. Changes you make in that device will not impact the definition in any manner.
|